Choose the language.
TKART magazine Doctor TKART | Mounting the kart’s seat in the correct position
Exclusive Content

Mounting the kart’s seat in the correct position

TKART Staff
17 December 2016
Installing the seat is not as simple as it seems. Both due to the difficulty of the job in itself and the importance that the correct position has on the rigidity of the chassis, the set-up and the kart’s reactions
alt
time 60 min
difficulty Hard
Advertisement

Looking at a kart superficially, it is easy for those with less expertise to consider the seat an “additional” accessory. Basically: there’s a frame, an engine, tyres, brakes, a steering wheel ...then, of course, you also need a piece of plastic (not that it is made of plastic...) on which to sit. Nothing could be more inaccurate, because a stark vehicle like a kart, on which everything is kept down to the bare bones, the seat has a very important role and becomes a fundamental part of the “chassis-system”. Indeed, the seat confers increased or decreased rigidity.
Furthermore, its position has a significant influence on the set-up and the way the kart responds.
So...listen to the “doc.” and these instructions on how to install a seat on the chassis properly.

NECESSARY TOOLS
A 5 MM ALLEN WRENCH
A CLAMP
A MARKER PEN
A 13 MM WRENCH
AN ELECTRIC SCREWDRIVER WITH AN 8MM BIT
BRACKETS FOR SEAT MOUNTING
alt
1
STEP
5 MIN

It may seem trivial, but the first step is to choose the right sized seat. It’s nothing complicated, just sit in an unmounted seat and rest your hands to the sides of your torso, at the height of your ribs, in order to mimic the thickness of a rib protection vest (which must always be used). Now, having placed the kart on a trolley to make working on it less complicated, place the seat chosen onto the chassis and begin positioning it using the special jigs (lower bracket and rear bracket).

1. Choose the right size of seat, simulating the thickness of the rib protection vest
alt
2. Place the seat onto the chassis
alt
3. Use the jigs to position the seat correctly
alt
2
STEP
10 MIN

The first jig should be placed exactly under the seat, in order to determine the height of the seat bottom. Use the second jig and a tape measure to measure the distance between the axle and the upper/rear edge of the seat, which must be the same as the one supplied by the kart manufacturer (it is usually about 20 cm). The next measurements needed are those between the seat tabs and the front tube. Caution: the distance of the right tab must be greater than the left one. Indeed, the seat should be mounted in an asymmetric position on the kart.

4.

Measure the distance between the seat tabs and the front tube of the bodyshell

5. Measure the distance between the axle and the edge of the seat
alt
Continue reading the article by subscribing for only 0.96 € / week
11
Explore these and many other
premium contents
Go to Magazine